TAP – TEST ACCESS POINT
The Industrial Ethernet TAP seamlessly duplicate full-duplex 10/100 Mbps traffic at wire speed. It provides monitoring devices with an accurate copy of the traffic with no impact on the network. It monitors all 7 OSI layers, and mirror packets of all sizes and types, low-level errors, and VLAN traffic.
The device makes even this faulty data available for analysis using standard diagnostic tools such as Wireshark
The Industrial Fast Ethernet Copper TAP is non-intrusive, has no IP address and isolate monitoring devices from the network to ensure complete stealth and security. The Industrial Fast Ethernet TAP network link is fully passive, ensuring a permanent network link at all times with zero failover time or link restoration delay.
TAP Helmholz facilitates non-intrusive monitoring.
- Non-intrusive in-line monitoring
- Permanent network link guaranteed
- Zero failover time or link restoration delay
- Monitoring of all 7 OSI layers
- No packet loss, no point of failure
- Fully 802.3af & VoIP compliant
- Low power consumption
- Tested with major analysis & monitoring systems
TAP Helmholz vs SPAN
- TAP Helmholz is impervious to hacking. Invisible, isolates monitoring devices from the network, no IP/MAC address.
- TAP Helmholz is passive and non-intrusive. Doesn’t alter the data. The SPAN is non-passive, alters packets’ timing, adds delay.
- The SPAN doesn’t copy all traffic. TAP Helmholz copies all traffic, al packets of anysize and type.
- The SPAN cannot handle full-duplex traffic drops packets if overloaded, may also interfere with main switch operation. TAP Helmholz copies full-duplex traffic at wirespeed.
| Connectors | 4x RJ45 – 8 pin |
| Power input | 1x 20-30 VDC |
| Dimensions (WxDxH) | 113 x 88 x 30 mm |
| Latency | Less than 1 ns |
Environmental Specifications:
- Operating Temperature: 0°C to 70°C
- Storage Temperature: -40°C to 120°C
- Humidity: 10 to 95%, non-condensing
- DIN Rail
You can request more information by clicking here.
